Removing and installing side airbag crash sensor on driver side G283 (Golf estate 2010 ► - USA) — VW
Removing and installing side airbag crash sensor on driver side G283 (Golf estate 2010 ► - USA) on VW: 8 steps, 2 torque figures.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf V / Jetta (1K, 2003–2009); platform code AJ5
Don't miss
- Only in this way is the correct installation position of the front airbag crash sensor on driver side G283 assured.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 4.5 Nm (3.3 lb-ft) | Insert and tighten bolt (2 |
| 4.5 Nm (3.3 lb-ft) | Unscrew bolt (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- ⚠ Observe the general safety regulations when working on airbag, belt tensioner and battery isolator units (pyrotechnic components) — Disconnect vehicle battery. Electrical system27Disconnecting and reconnecting battery
- Release connector locking mechanism and pull off connector (1) from front airbag crash sensor on driver side G283(3).
- Unscrew bolt (2) (4.5 Nm) and remove front airbag crash sensor on driver side G283(3). — 4.5 Nm (3.3 lb-ft)
- Insert front airbag crash sensor on driver side G283(3) in such a way that lug (arrow A) engages in hole (arrow B). [Note: Only in this way is the correct installation position of the front airbag crash sensor on driver side G283 assured.]
- Insert and tighten bolt (2) (4.5 Nm). — 4.5 Nm (3.3 lb-ft)
- Fit connector (1) and engage connector locking mechanism.
- Switch on ignition.
- ⚠ Ensure that nobody is in vehicle. — Connect vehicle battery. Electrical system27Disconnecting and reconnecting battery
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Installing right spring – VW Golf IV / Bora
- Removing and installing rear flange shaft – VW Phaeton
- Installing wiper motor in front passenger side wiper frame
- Removing positioning element – VW Passat B5 · 1 torque figures
- Removing and installing additional relay carrier with additional fuse holder · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.