Removing and installing shock absorbers, basic version, four-wheel drive — VW

🧭 Before you start

Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)

📋 Procedure

1. Loosen wheel bolts.
2. Raise vehicle.
3. Remove wheel.
4. Remove wheel housing liner General body repairs, exterior 66. Wheel housing liner; Removing and installing wheel housing liner.
5. Remove coil spring (see the separate procedure).

6. Remove bolts (1) for shock absorber (2).
7. Remove bolt (arrow).
8. Remove shock absorber.
9. Install shock absorber (2) and tighten bolts (1).
10. Tighten bolt (arrow).
11. Install coil spring (see the separate procedure).
12. Install rear wheel housing liner General body repairs, exterior 66. Wheel housing liner; Removing and installing wheel housing liner.
13. Install wheel and tighten bolts or nuts (see the separate procedure).

🎬 Video walkthrough

Independent video tutorial by AUTODOC (YouTube) — a helpful visual companion to the steps above.

How to change rear shock absorber on VW PASSAT B7 Saloon

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Steering column electronics control unit J527 ► 10.2009
• Notes on repairs to airbag and belt tensioner wiring
• Assembly overview – rear brake, multi-link rear suspension
• Removing and installing regulating flap control unit J808 and throttle valve module J338
• Removing and installing engine control unit J623 and engine control unit 2 J624