Removing and installing seat height adjustment, except electrically adjustable seat — VW

🧭 Before you start

Don't miss

• Bolts (1) and bolt (3) are of different lengths.Bolt (3) is shorter.The head of bolt (3) is larger.Ensure proper allocation.

📋 Procedure

1. Adjust seat to fully upright position.
2. Remove backrest adjustment (see the separate procedure).
3. Remove handle for seat height adjustment (see the separate procedure).
4. Remove seat trim on sill side (see the separate procedure).
5. Remove bolts (2).

6. Remove lever (1).
7. Remove lock washer (1).
8. Remove bolts (1) and (3).
9. Remove seat height adjuster (2). [Note: Bolts (1) and bolt (3) are of different lengths. Bolt (3) is shorter. The head of bolt (3) is larger. Ensure proper allocation.]
10. Push down seat via backrest.
11. Fit seat height adjustment (2).
12. Tighten bolts (1) and (3)

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking tank venting valve
• Removing and installing clutch cable (from 27.04.95)
• Adjusting selector mechanism (rod selector mechanism)
• Removing and installing final drive gear wheel
• Dismantling and assembling vehicles without ignition key removal lock up to 06.99