Removing and installing rear air ducts — VW

🧭 Before you start

Fits: platform codes 5C7, 5C1

📋 Procedure

1. Disconnect battery Electrical system27.
2. Remove driver and front passenger seats General body repair, interior72.
3. Remove centre console General body repair, interior68.
4. Remove cover for foot support General body repair, interior68.
5. Detach floor covering in driver footwell and on front passenger side.

6. Fold back floor covering enough so that both air ducts are completely visible.
7. Detach air ducts (2) from floor panel (3) and lift up slightly.
8. Pull off air ducts (2) from heater and air conditioning unit (1).
9. Fit air ducts (2) (angled slightly) on heater and air conditioning unit (1).
10. Clip in air ducts (2) on floor panel (3).
11. Check again that air ducts (2) are seated correctly on heater and air conditioning unit (1).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Installing gearbox, CC, Golf Cabriolet, vehicles with 1.4 l petrol engine, engine lifting eyes »at front« of engine
• Installing gearbox, CC with 1.8 l petrol engine
• Removing gearbox, Golf Cabriolet, vehicles with turbo diesel engine, engine lifting eyes »next to each other« on engine
• Installing gearbox, Golf Cabriolet, vehicles with turbo diesel engine, engine lifting eyes »next to each other« on engine
• Removing and installing fuel tank 2 – VW CPGA