Removing and installing footwell vent air ducts for 2nd row of seats — VW

🧭 Before you start

Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)

📋 Procedure

1. Disconnect battery Electrical system27.
2. Remove driver and front passenger seats General body repair, interior72.
3. Remove centre console General body repair, interior68.
4. Remove cover for foot support General body repair, interior68.
5. Release carpet in footwell.

6. Fold carpet back, to rear, until the air ducts are completely visible.
7. Release air ducts (1 and 2) from floor, then pull off of heater air conditioning unit.
8. Fit air ducts (angled slightly) on heater and air conditioning unit.
9. Clip air ducts onto floor.
10. Check air ducts are seated correctly on heater and air conditioning unit.
11. The remaining steps for installation are carried out in reverse order.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking engine operating mode
• Checking driving characteristics after a cold start
• Matching engine control unit to throttle valve control part
• Checking air conditioner compressor signal
• Servicing injection pump