Removing and installing power-assisted steering rack: VW Jetta VI

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

Don't miss

• Loosen nut on track rod ball joint but do not remove completely.

📋 Procedure

1. Turn steering wheel to straight-ahead position and remove ignition key so that the steering lock engages.
2. Switch off ignition and open driver's door so that the steering lock engages.
3. Unscrew bolts (1) and remove footwell trim (2).
4. Unscrew bolt (arrow) from universal joint (1) and pull off universal joint in (direction of arrow).
5. Clamp off suction and return hoses at power steering oil reservoir.

6. Clamp off suction and return hoses at power steering oil reservoir.
7. Loosen wheel bolts.
8. Raise vehicle.
9. Remove front wheels.
10. Remove lower noise insulation General body repairs, exterior 50. Assembly overview - noise insulation.
11. Detach exhaust system bracket from subframe (arrows).
12. Loosen double clamp of exhaust system.
13. Remove hexagon nut (1) from coupling rod (3) (left and right sides).
14. Pull out coupling rod (3) from anti-roll bar (2) on left and right side.
15. Remove nuts (arrows) on left and right sides of vehicle.
16. Pull swivel joint out of suspension link.
17. Loosen nut on track rod ball joint but do not remove completely.
18. ⚠ Leave nut screwed on a few turns to protect thread on pin. — Push track rod ball joint off wheel bearing housing and remove nut.
19. Remove bolts (9) and (10) for steering rack.
20. Disconnect pendulum support from gearbox by removing bolts (11).
21. Fix position of subframe (see the separate procedure).
22. Disconnect pressure and return lines (1) from steering rack.
23. Position engine and gearbox jack V.A.G 1383 A(1) under subframe
24. Remove bolts (5) and (6) and lower subframe with engine and gearbox jack V.A.G 1383 A.
25. Take power-assisted rack out to rear.
26. Install noise insulation and tighten, specified torque General body repairs, exterior 50. Assembly overview - noise insulation.
27. Install front wheels and tighten (see the separate procedure).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing receiver · 1 torque figures
• Removing and installing fuel filter, engine codes CKRA, CFFB
• Removing and installing starter, 1.6 l, 77 kW TDI engine, manual gearbox MQ250-5F
• Removing and installing airbag unit on driver side ► week 45/2015
• Removing and installing seals – VW Golf Cabriolet · 1 torque figures