Removing and installing fuel filter, engine codes CKRA, CFFB — VW

🔧 Engine codes this applies to

📋 Procedure

1. Observe safety precautions (see the separate procedure).
2. Observe rules for cleanliness (see the separate procedure).
3. Observe notes reference fuel hoses in the engine compartment (see the separate procedure).
4. Detach plug-on connectors (A) and (B) of fuel lines. Separate plug-in connectors (see the separate procedure).
5. Unclip bracket for coolant hose (1).

6. Then, move fuel filter clear to one side with lines attached.
7. Undo bolts in the sequence shown.
8. Catch any escaping fuel.
9. Detach plug-on connectors (A) and (B) of fuel lines. Separate plug-in connectors (see the separate procedure).
10. Unclip bracket for coolant hose (1).
11. Open clips and pull off fuel hoses (2) to (4).
12. Disconnect plug connector (1) on the fuel temperature sender G81.
13. Unclip fuel hoses.
14. Unscrew filter (7) on the mountings (1) to (3).
15. Take fuel filter out upwards.
16. Catch any escaping fuel.
17. Bleed fuel system 23Injection system; Filling/bleeding fuel system.

Other VW procedures

• Removing and installing pendulum support – VW Polo 6R · 1 torque figures
• Checking the delivery pressure of the fuel pump (0.5 bar low-pressure fuel system)
• Removing and installing fuel tank, all vehicles apart from Jetta from MY 2011
• Removing and installing fuel tank, only Jetta from MY 2011
• Removing and installing coolant pipe (top front) – Audi A3
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures