Removing and installing seals: VW Golf Cabriolet
Step-by-step removing and installing seals for the VW Golf Cabriolet: 7 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf Cabriolet (517, 2011–2016)
Don't miss
- Spray the seal with soapy water so that it can be pushed onto the retaining strip with more ease.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 5 Nm (3.7 lb-ft) | Tighten seal with retaining strip |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Unscrew bolts (6) of retaining strip (5) through openings in seal (1).
- Remove retaining strip with seal from soft top.
- Remove washers and record quantity.
- Pull off seal (1/2/3/4) from bottom ledge first (arrow a).
- Then pull off from upper ledge (arrow b) and finally from middle ledge (arrow c). [Note: Spray the seal with soapy water so that it can be pushed onto the retaining strip with more ease.]
- Push seal onto long middle ledge first and then attach it at the top and bottom.
- Tighten seal with retaining strip. Torque setting: 5 Nm. — 5 Nm (3.7 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing engine control unit J623, engine control unit with metal locking plate
- Connecting fault output device V.A.G 1551 and selecting function
- Servicing air conditioner and heater - engine compartment
- Servicing magnetic coupling -N25- with compressor removed; Sanden
- Servicing magnetic coupling -N25- with compressor removed; Denso
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.