Removing and installing operating and display unit, to week 44/10 — VW
Removing and installing operating and display unit, to week 44/10 on VW: 3 steps, 1 torque figure. What to remove, what to tighten and to how many Nm.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat CC (357, 2008–2012), VW Passat B6 (3C, 2005–2010), VW CC (358, 2012–2017)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Unscrew bolts |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove centre dash panel trim General body repairs, interior68Centre console; Assembly overview - centre console.
- Unscrew bolts (1.5 Nm) (2) and remove operating and display unit for Climatronic air conditioning system E87 with Climatronic control unit J255(1) from dash panel. — 1.5 Nm (1.1 lb-ft)
- Disconnect connectors on operating and display unit for Climatronic air conditioning system E87.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing steering angle sender G85
- Emptying fuel tank with fuel pump intact, engine codes CFHC, CFHF, CFJA, CLCA, CFJB
- Removing and installing fuel delivery unit/fuel gauge sender, version 2
- Removing and installing fuel gauge senderG, version 1 – VW
- Installing new securing straps – VW Touran I BSX/CDGA
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.