Removing and installing oil pressure switch F1 — VW

🧭 Before you start

Fits: platform codes 602, 604, 603

• Renewed: seal

🔧 Engine codes this applies to

📐 62 workshop diagrams for CLNA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove engine cover panel .
2. Remove crankcase breather hose (1), press release buttons for this.
3. Free vacuum hoses (arrows).
4. Release hose clips (3) and pull air hose off air filter housing.
5. Unscrew bolt (2), swing intake hose with intake connection to rear and pull off of turbocharger.

6. Unscrew bolts (2) and (3), remove engine lifting eyes (1).
7. Disconnect electrical connector (arrow).
8. Remove oil pressure switch F1. [Note: Renew the seal.]
9. Install vacuum line to exhaust gas recirculation cooler.
10. Install intake connection.

Other VW procedures

• Removing and installing exhaust gas recirculation system
• Removing and installing high-pressure accumulator – VW Polo 6R · 1 torque figures
• Removing and installing oil filter bracket with engine oil cooler
• Removing camshafts – VW Touareg I
• Removing and installing intake manifold (vehicles with intake manifold flap V157)
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures