Removing and installing moulded headliner, 4-door models: VW Polo 6C

🧭 Before you start

Fits: VW Polo 6C (2014–2017)

Don't miss

• If caps (1) and (4) become damaged while being removed, these must be renewed.
• Lower moulded headliner with the help of a second mechanic (danger of breakage) and pull out from C-pillar trim in direction of travel.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. If a panorama tilting/sliding sunroof is installed, open it.
2. Carefully detach surround (1) of panorama tilting sunroof from clips (2) using removal wedge3409 and remove it.
3. Remove front interior and reading light Electrical system96Controls; Removing and installing front interior light/reading light.
4. Remove light for vanity mirror Electrical system96Lights; Removing and installing illuminated vanity mirror W20/W14.
5. Remove rear interior light W43Electrical system96Controls; Removing and installing rear interior light/reading light.

6. Remove sun visors .
7. Remove interior mirror:
8. Remove upper A-pillar trims .
9. Remove roof grab handles .
10. Release upper B-pillar trims from mountings (4-door models) .
11. Remove roof end strip .
12. Fold bench seat forwards.
13. In vehicles with interior monitoring, unscrew bolts (1) and (2) (3 Nm). — 3 Nm (2.2 lb-ft)
14. Remove retaining clip (1) beneath roof end strip.
15. Unclip cover caps (1) and (4) with removal wedge3409 and remove inner sun visor bearings (2) and (3). [Note: If caps (1) and (4) become damaged while being removed, these must be renewed.]
16. Lower moulded headliner with the help of a second mechanic (danger of breakage) and pull out from C-pillar trim in direction of travel.
17. Remove moulded headliner (1), with help of second mechanic, from vehicle through rear lid.
18. Secure surround (1) of panorama tilting/sliding sunroof to clips (2) of moulded headliner.
19. Further installation is performed in the reverse order of removal.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing relay carrier with automatic fuses on left of dash panel
• Checking combi-valves for secondary air – VW CBRA
• Removing and installing starter, vehicles with 2.0 l TDI engine and dual clutch gearbox DQ500-7F
• Removing and installing (Passat, Passat CC) – VW CKMA
• Removing and installing splash plate, torsion beam rear axle