Removing and installing splash plate, torsion beam rear axle — VW

🧭 Before you start

Fits: platform codes AU1, BX5

• Opens: brake fluid

Don't miss

• Do not blow out brake system with compressed air; the resulting dust constitutes a health hazard! — Secure brake caliper with new self-locking bolts Electronic Parts Catalogue "“ETKA”".

📋 Procedure

1. Loosen wheel bolts.
2. Raise vehicle.
3. Remove wheel.
4. Remove brake carrier .
5. Remove brake disc .

6. Remove wheel bearing unit Running gear, axles, steering42Suspension link wheel bearing; Assembly overview - wheel bearings.
7. Unscrew bolts (arrows) for splash plate (1).
8. Remove splash plate (1) together with stub axle.
9. ⚠ Do not blow out brake system with compressed air; the resulting dust constitutes a health hazard! — Secure brake caliper with new self-locking bolts Electronic Parts Catalogue.
10. Install wheel and tighten.
11. Firmly depress brake pedal several times with vehicle stationary so that the brake pads are properly seated in their normal operating position.
12. Check brake fluid level.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing bumper cover, Polo »BlueMotion«
• Removing and installing bumper cover, CrossPolo
• Removing and installing engine mounting, Polo – VW CHZB/CHZC
• Removing and installing engine control unit J623 with metal locking plate, Golf, Golf Estate, Golf SV
• 5-speed manual gearbox 02T — Bleeding clutch mechanism