TorqFix

Removing and installing left headlight — VW

Removing and installing left headlight on VW: 10 steps. What to remove, in what order, and what to check after.

Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.

10 steps

🧭 Before you start

Fits: platform codes 9C1, 1C1, 1Y7

📋 Procedure

  1. ⚠ Switch off ignition and all electrical consumers.Remove the ignition key. — Open clamp (1).
  2. Press release (2) downwards and slide lever (3) upwards.
  3. Pull headlight (4) forwards slightly.
  4. Disconnect connector on headlight.
  5. Take headlight out forwards.
VW? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Fit connector (1) onto headlight.
  2. Position headlight insert on guide rails (arrows) and slide to rear.
  3. Move lever in engine compartment downwards again and lock clamp.
  4. Check function of headlight.
  5. Checking and adjusting headlight .

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.