Removing and installing inner door cover — VW

🧭 Before you start

Fits: platform codes 5C7, 5C1

📋 Procedure

1. Remove door trim General body repairs, interior70Front door trims; Removing and installing front door trim.
2. Detach connectors for crash sensor for side airbag on driver side G179, for driver door exterior handle switch F272 and, if present, for exterior door handle touch sensor on driver side G415(2).
3. Unclip electric cable from retainers (3).
4. Lift lower end of cover (1).
5. Pull cover (1) downwards and remove from door.

6. Pull cable (4) with grommet as well as wiring harness (5) with grommet out of cover.
7. Pull cable (4) as well as wiring harness (5) through cover (1) and secure grommets.
8. Insert top part of cover (1) into door.
9. Press bottom part of cover (1) onto door.
10. Clip electric cable into retainers (3).
11. Attach connectors for crash sensor for side airbag on driver side G179, for driver door exterior handle switch F272 and, if present, for exterior door handle touch sensor on driver side G415(2).
12. Install door trim General body repairs, interior70Front door trims; Removing and installing front door trim.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing rear side window – VW Passat B8
• Removing and installing front mid-range loudspeakers · 1 torque figures
• Bleeding clutch mechanism
• Assembly sequence - differential
• Removing and installing alternator, 2.0 l, 100 kW or 103 kW TDI engine