Removing and installing wheel bearing unit, vehicles with disc brake — VW
Removing and installing wheel bearing unit, vehicles with disc brake on VW: 12 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6C (2014–2017)
- Special tools named: puller
📋 Procedure
- Raise vehicle.
- Remove wheel.
- Loosen grease cap from seat by tapping lightly on the claw of the hub grease cap puller VW 637/2.
- Pry off grease cap.
- Unscrew brake caliper and hang up on body.
- Remove bolt for brake disc and remove brake disc.
- Remove 12-point nut.
- Pull wheel hub/wheel bearing unit from stub axle.
- Carefully push wheel hub/wheel bearing unit onto stub axle.
- Tighten new 12-point nut.
- Drive in dust cap.
- Install wheel and tighten bolts or nuts .
🎬 Video walkthrough
Independent video tutorial by AUTODOC (YouTube) — a helpful visual companion to the steps above.
How to change rear wheel bearing VW Polo TUTORIAL
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Calibrating ACC during vehicle alignment
- Removing and installing rain and light sensor G397, vehicles with front camera for driver assist systems
- Removing and installing rain and light sensor G397, vehicles without front camera for driver assist systems
- Removing and installing steering column combination switch E595, Valeo, interface for entry and start system
- Removing and installing steering column combination switch E595, Kostal, interface for entry and start system
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.