Removing and installing interface for portable navigation and infotainment system J983 — VW

🧭 Before you start

Fits: platform codes 121, BL1

Don't miss

• When installing, ensure that wires are fitted in place correctly in order to avoid damage.

📋 Procedure

1. Removing and installing radio and radio/navigation systems
2. Remove air-conditioning control and display unit Air-conditioning system87Control and display unit
3. Remove heater control and display unit Heater80Control and display unit
4. Remove bracket and, if necessary, portable navigation and infotainment system J982.
5. Remove bolts (arrows).

6. Remove 12-pin connector from four-block connector.
7. Detach aerial wire from radio.
8. Unclip and remove retaining bracket (1) from the holder (2).
9. Pull off retaining clips for wiring harness.
10. Remove interface for portable navigation and infotainment system J983 upwards together with wiring harness. [Note: When installing, ensure that wires are fitted in place correctly in order to avoid damage.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Starter B ((vehicles with 09A automatic transmission) - remove and install
• Servicing charge with the Battery chargerVAS 5900 – VW Fox
• Back seat belt (central, 2-door Gol) - remove and install · 1 torque figures
• Rear central seat belt (4-door Gol and Parati) - remove and install · 1 torque figures
• Gearbox input speed sensor G182