Starter B ((vehicles with 09A automatic transmission) - remove and install — VW

🧭 Before you start

Fits: platform codes 9B1, 9B3

Don't miss

• Do not release screw (2).Do not bend the selector lever cable

📋 Procedure

1. Turn off the ignition, all the electrical devices, and remove the key from ignition.
2. Disconnect the BatteryA .
3. Remove the engine cover. For some engines, it is necessary to remove the fastening nuts (arrows) in order to remove the engine cover.
4. Remove the intake tube (1), the connector (2) and the flexible tube (3) from the Air density meter G70.
5. Release fastening screws (4) and (5) and remove the air filter.

6. Release the transmission (arrow) support.
7. Position the selector lever on "“P”" and remove the selector lever cable (1) from the selector arm (4) using a screwdriver.
8. Release the stop (3) on the selector lever counter support and remove the selector lever cable. [Note: Do not release screw (2).Do not bend the selector lever cable]
9. Remove the plastic cover from the (1) magnetic switch.
10. Remove the positive cable (1) from the magnetic switch.
11. Disconnect terminal 50 (2) from StarterB.
12. Release the fastening screw (1) and nuts (2).
13. Remove the StarterB from the transmission by moving it up.
14. Tighten the fastening nuts to the specified torque.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Calculating shims for clutch housing
• Adjusting door fittings for flushness – VW Golf V / Jetta · 4 torque figures
• Removing gearbox, vehicles with 2.5 l - 110 kW and 2.5 l - 125 kW engines
• Removing and installing cylinder head, engine codes AWY, BMD, BBM · 1 torque figures
• Removing front belt anchor rail (2-door) – VW Polo 9N · 4 torque figures