Gearbox input speed sensor G182 — VW

🧭 Before you start

Fits: platform codes 5U2, 5U1

• Renewed: fastening screws

📋 Procedure

1. Turn off the ignition and all electrical equipment, and remove the key from ignition.
2. Disconnect the BatteryAElectrical devices27 Starter motor, alternator, battery.
3. Remove the air filter, it is installed behind the BatteryAEngine24Fuel supply - injection system.
4. Remove the fastening screws (3 units) , for the hydraulic set "“Power Pack”" .
5. Lift the vehicle.

6. Disconnect the connector (1) from the Gearbox rotation sensor G182(3). To facilitate operation, use the Hook T10118 and at the same time, slightly move the hydraulic set "“Power Pack”"(2) upwards.
7. Remove the fastening screw (arrow).
8. Remove the Gearbox rotation sensor G182(3).
9. Replace the sealing ring (O-ring) Transmission input speed sensor G182.
10. Replace the fastening screws.
11. Tighten the fastening screw (arrow) for the Gearbox rotation sensor G182(3) with a torque of .
12. Install new fastening screws from the hydraulic set "“Power Pack”". Tightening torque, see .
13. Lower the vehicle.
14. After installation, perform self-diagnostic and basic adjustments .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Tightening torque · 1 torque figures
• Removing and installing drive shafts with triple roller joint
• 02T Gearbox — Dismantling and assembling output shaft
• Removing and installing speed sensor on rear axle (disc brakes - four-wheel drive) · 1 torque figures
• Repairing drive shaft