Removing and installing gearbox input speed sender G182: VW CC

🧭 Before you start

Fits: VW CC (358, 2012–2017)

• Opens: gearbox oil

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Drain ATF .
2. Remove oil pan .
3. Remove ATF strainer .
4. Remove valve body .
5. Unscrew bolt (1) from gearbox input speed sender G182.

6. Pull out gearbox input speed sender from gear housing.
7. Push gearbox input speed sender into gear housing onto stop.
8. Tighten bolt (1) for gearbox input speed sender G182; torque specifications .
9. Install valve body .
10. Install ATF strainer .
11. Install oil pan .
12. Fill with ATF; check ATF level and top up .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Dismantling: notes
• 5-speed-manual-gearbox-(02T and 0AP) — Planet pinion - disassemble and assemble
• Removing and installing thermal fuse – VW Golf IV / Bora 2.0 · 1 torque figures
• Dismantling and assembling power assisted steering box (ZF)
• Codes, gearbox allocation, ratios, equipment