Removing and installing gas filter (Golf ▶ 2011 and Golf Plus ▶ 2011) — VW

🧭 Before you start

Fits: VW Golf VI (5K, 2008–2013); platform code 521

Don't miss

• Ensure that you install filter in correct direction. The direction is marked on filter.

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📐 26 workshop diagrams for CHGA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. ⚠ There is a danger from escaping gas.The system is pressurised.Before opening the system place a cloth around the connection. Then release pressure by carefully loosening the connection.Wear suitable protection such as eye protection and protective gloves. — Loosen hose clips (arrows).
2. Pull gas hoses off hose connections and remove filter.
3. Install new filter. [Note: Ensure that you install filter in correct direction. The direction is marked on filter.]
4. Position clamps and secure (3.5 Nm) — 3.5 Nm (2.6 lb-ft)
5. Check gas system for leaks once installation is complete 26.1.

Other VW procedures

• Checking semi-automatic toothed belt tensioner – VW · 1 torque figures
• Sealing upper and lower covers · 3 torque figures
• Removing and installing front exhaust pipe with catalytic converter
• Removing toothed belt
• Removing and installing valve stem seals
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures