Removing and installing fuse holder CSC: VW Polo 6C
Step-by-step removing and installing fuse holder CSC for the VW Polo 6C: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6C (2014–2017)
Don't miss
- The exact pin assignment should be gleaned from the latest current flow diagram .If necessary, take photographs of the assignment.
- The exact fuse assignment can be found in the latest current flow diagram .Take photographs of the fuse assignment, if necessary.
📋 Procedure
- With ignition switched off, disconnect earth cable from battery .
- Pull cover (1) of fuse holder CSC at bottom out of fasteners (arrow A), and remove it from dash panel.
- Remove left footwell light W9.
- Remove footwell vent on driver side Heating, air conditioning80Air duct; Removing and installing driver side footwell vents.
- Unscrew bolts (arrows) for fuse holder CSC.
- Guide out fuse holder CSC towards inside as far as the wiring allows.
- Disconnect connectors and wires from fuse holder CSC. [Note: The exact pin assignment should be gleaned from the latest current flow diagram .If necessary, take photographs of the assignment.]
- Remove fuse holder CSC.
- Make a note of the fuse assignment, and remove all fuses from the fuse holder CSC. [Note: The exact fuse assignment can be found in the latest current flow diagram .Take photographs of the fuse assignment, if necessary.]
- Connecting battery .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing front air distribution flap actuation unit, heater and air conditioning system with electric/manual controls
- Removing and installing left headlight
- Removing and installing headlight range control motor, from 07.05
- Adjusting selector mechanism, gearbox with retaining pin (through gearbox date 18 05 3)
- Adjusting selector mechanism, gearbox with angled rod from gearbox date 19 05 3)
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.