Removing and installing fuse holder BSB on battery — VW
Removing and installing fuse holder BSB on battery on VW: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 6Z1
📋 Procedure
- Remove bonnet General body repairs, exterior55Bonnet; Removing and installing bonnet.
- Disconnect battery .
- Release cover (1)(arrows).
- Remove cover (1).
- Remove nuts (1).
- Pull off lines (2).
- Remove nut (2).
- Pull off fuse carrier (3) upwards.
- Remove bolt (1).
- Remove fuse holder (4).
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing washer fluid reservoir – VW Tiguan I
- Installing front wheel housing trim – VW Polo 6R · 1 torque figures
- Installing rear wheel housing trim – VW Polo 6R · 1 torque figures
- Checking delivery pressure of hydraulic pump with electric motor (motor/pump unit)
- Removing and installing fuel pressure regulating valve N276
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.