Removing and installing fuse holder BSB: VW Golf Sportsvan

🧭 Before you start

Fits: VW Golf Sportsvan (AM1, 2014–2020)

Don't miss

• Mark allocation of electrical wiring at threaded connections for reinstallation.

📋 Procedure

1. With ignition switched off, disconnect earth cable from battery .
2. Press release buttons (arrows).
3. Remove cover (1) for electronics box in engine compartment.
4. Using screwdriver, release retaining tab (2).
5. Pull off front cover (1) upwards (arrow).

6. Mark allocation of electrical wiring at threaded connections for reinstallation.
7. Unscrew nuts (1, 2, 4, 5 and 6).
8. Remove bolt (3).
9. Move electrical wiring clear (arrow).
10. Cut through cable tie (bottom) on wiring harness.
11. Release fasteners (1, 2 and 4) in direction of (arrow).
12. Remove fuse holder B (3), and lay it to one side.
13. Fit and secure electrical wiring to fuse holder A according to markings made earlier.
14. Connect battery .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking electronically controlled cooling system – VW 1.6 AVU
• Overview - "“K2/K3”" clutch housing
• Removing and installing air conditioner magnetic clutch N25
• Checking operation of the ignition key withdrawal lock
• Checking cooling system for leaks using cooling system testerV.A.G 1274 B