Removing and installing front securing bracket: VW Jetta VI
Step-by-step removing and installing front securing bracket for the VW Jetta VI: 4 steps, 2 torque figures.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Jetta VI (16, 2010–2018); platform code AV2
- Renewed: if necessary
Don't miss
- Removal of front right securing bracket is identical.
- Before installing, check snap-on nut (3) for damage and renew if necessary.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2.0 Nm (1.5 lb-ft) | Undo 2 nuts (2 |
| 2.0 Nm (1.5 lb-ft) | Unscrew nuts (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition.
- Remove centre console:
- Undo 2 nuts (2) (2.0 Nm) and remove securing bracket (1). [Note: Removal of front right securing bracket is identical.] — 2.0 Nm (1.5 lb-ft)
- Install in reverse order of removal. [Note: Before installing, check snap-on nut (3) for damage and renew if necessary.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- 6-speed manual gearbox 01E, four-wheel drive — Dismantling and assembling pinion shaft and hollow shaft
- Removing transfer box – VW Touareg I
- Vehicles with centre three-point seat belt · 2 torque figures
- Removing and installing alternator, 1.9 l TDI engine with no DSG
- Renewing left flange shaft oil seal with manual gearbox installed · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.