Removing and installing front passenger side footwell vents (LHD) — VW
Removing and installing front passenger side footwell vents (LHD) on VW: 6 steps, 2 torque figures. What to remove, what to tighten and to how many Nm.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code BE1
Don't miss
- If the vehicle has glove compartment cooling, ensure that the coolant hose is properly seated.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 0.2 Nm (0.1 lb-ft) | Remove securing bolt (2 |
| 0.2 Nm (0.1 lb-ft) | Tighten bolt (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove glove compartment General body repairs, interior68Compartments/covers; Removing and installing glove compartment.
- If fitted, unscrew bolt (2).
- Remove bolts (3).
- Push clip (4) upwards in (direction of arrow) and detach footwell vent on front passenger side.
- Pull out dash panel frame slightly.
- Remove footwell vent on front passenger side. [Note: If the vehicle has glove compartment cooling, ensure that the coolant hose is properly seated.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Renewing right oil seal, gearboxes with flange shaft
- Removing and installing subframe without steering rack, except for e-Golf
- Emptying fuel tank if it is less than 3/4 full (petrol)
- Renewing seal for propshaft output flange on bevel box – VW
- Removing and installing high-voltage battery charging socket 1UX4
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.