Removing and installing driver side footwell vents: VW Sharan II / SEAT Alhambra

🧭 Before you start

Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Disconnect battery Electrical system27.
2. Remove knee airbag General body repair, interior69.
3. Remove footwell trim panel on driver side General body repair, interior70.
4. Remove bolt (1) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
5. Pull footwell vent (2) off heater and air conditioning unit in (direction of arrow).

6. Install footwell vents in reverse order of removal, ensuring correct seating on heater and air conditioning unit.
7. Install knee airbag General body repair, interior69.
8. Install footwell trim panel on driver side General body repair, interior70.
9. Reconnect battery Electrical system27.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Disconnecting reducing agent supply line
• Removing and installing exhaust gas temperature sender 3G495, CC
• Renewing seal between gearbox and bevel box with bevel box removed
• Removing and installing centre rear seat belts – VW Polo 6R · 1 torque figures
• Removing and installing side airbag (vehicles with curtain airbag) · 1 torque figures