TorqFix

Renewing seal between gearbox and bevel box with bevel box removed — VW

Renewing seal between gearbox and bevel box with bevel box removed on VW: 16 steps, engines CJXB, CJXC, CYFB.

Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.

16 steps 3 engine codes engine codes merged from 5 documented variants

🧭 Before you start

Fits: VW Sharan II / SEAT Alhambra (7N, 2010–), VW Tiguan I (5N, 2007–2016)

🔧 Engine codes this applies to

CJXBCJXCCYFB

📋 Procedure

  1. Remove bevel box .
  2. Remove bevel box .
  3. Remove bevel box .
  4. Remove bevel box .
  5. Remove bevel box .
CJXB? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. .
  2. Lever out seal using oil seal extractor lever T20143/2.
  3. Half-fill space between sealing lip and dust lip of new seal (arrow) with sealing grease.
  4. Lightly oil outer circumference of new oil seal.
  5. Drive in seal to stop.
  6. Install bevel box .
  7. Install bevel box .
  8. Install bevel box .
  9. Install bevel box .
  10. Install bevel box .
  11. Check gear oil in gearbox .

Other VW procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.