Removing and installing driver side footwell vents (LHD) — VW
Removing and installing driver side footwell vents (LHD) on VW: 5 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code BE1
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 0.2 Nm (0.1 lb-ft) | Remove securing bolt (2 |
| 0.2 Nm (0.1 lb-ft) | Tighten bolt (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Before handling electrical connector, the person handling it must "“electrostatically discharge”" himself/herself. Observe safety precautions for working on airbags General body repairs, interior00Safety information; Safety precautions for working with pyrotechnic components.
- Remove driver side knee airbag General body repairs, interior69Knee airbags; Assembly overview - knee airbag.
- Remove bolt (1).
- Remove footwell vent on driver side (2).
- Install in reverse order.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing brake pads, brake caliper FN 44
- Removing and installing brake caliper, brake caliper FN 44
- Removing and installing air compressor V534 and pressure accumulator
- Removing and installing expansion valve with refrigerant circulation solenoid valve N43
- Assembly overview - rear wheel suspension, four-wheel drive
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.