Removing and installing front part of operating and display unit — VW
Removing and installing front part of operating and display unit on VW: 5 steps, 2 torque figures. What to remove, what to tighten and to how many Nm.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 5C7, 5C1
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Remove bolts (1 |
| 1.5 Nm (1.1 lb-ft) | Unscrew bolts (2) from operating and display unit (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Disconnect battery Electrical system27.
- Remove trim (1) using removal wedge3409General body repairs, interior68Compartments, covers and trims.
- Unscrew bolts (2) from operating and display unit (3) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
- Remove bolts (1) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
- Remove front part of operating and display unit (3) from rear part. Separate wiring harness connectors (2) while doing so. [Note: The rotary knobs of the operating and display unit must be set to the same position (see removal) before installing.Only in this way can both housing halves be fitted back together.Following successful installation, a functional check must be carried out.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Rear seat belts (Saveiro "“double cab”") - remove and install · 2 torque figures
- Engines: AEG, AVH, AZG, APK, AQY, BEJ, BER, BEV, BHP · 2 torque figures
- Vehicles with central locking · 2 torque figures
- Fork selector lever case housing - remove and install · 2 torque figures
- Alarm system horn H8 - remove and install · 3 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.