Rear seat belts (Saveiro "“double cab”") - remove and install — VW

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove rear seat (see the separate procedure).
2. Remove the side lining (see the separate procedure).
3. Remove the lower fastening point of the rear seat belt (6).
4. Remove C-pillar upper lining (9).
5. Remove the seat belt clip (3).

6. Remove the securing bolt (2).
7. Remove the director (1).
8. Remove the securing bolt (5).
9. Remove the seat belt inertia reel (4).
10. Install the automatic belt retractor (4).
11. Tighten the securing bolt (5) to the torque of (40 Nm). — 40 Nm (30 lb-ft)
12. Install the belt guide (1).
13. Tighten the securing bolt (2) to the torque of (40 Nm). — 40 Nm (30 lb-ft)
14. Install the seat belt clip (3).
15. Install C-pillar upper lining (9).
16. Install the lower fastening point of the rear seat belt (6).
17. Install the side lining

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing left-hand flange shaft oil seal
• Disconnecting battery
• Removing and installing additional brake light bulb M25 – VW
• Removing and installing interior aerial 2 for entry and start authorisation R139
• Removing and installing front parking aid senders – VW