Disconnecting battery — VW
Disconnecting battery on VW: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touareg I (7L, 2002–2010)
📋 Procedure
- Switch off ignition and all electrical consumers and pull out ignition key.
- Remove front and side trim on front left seat frame.
- Remove seat spindle covers.
- Remove seat slide rail cover caps.
- Remove securing bolts (arrows).
- Tilt seat frame and seat to rear (arrow).
- Remove bolt (1) and remove air duct (2).
- Open battery box latches (arrows) and remove cover.
- Unbolt battery earth cable (1) from battery negative terminal.
- Unbolt battery positive cable (2) from battery positive terminal.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing moulded headliner (2-door models) – VW · 1 torque figures
- Removing and installing steering column (Polo hatchback IN, Polo saloon IN, Polo saloon SA, Polo hatchback MY, Polo saloon MY) · 1 torque figures
- Removing and installing steering column (Polo saloon RUS) · 1 torque figures
- Removing and installing steering column, left-hand drive, vehicle with no knee airbag
- Checking valve timing, engine codes CPTA, CZEA – VW CPTA/CZEA · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.