Removing and installing front belt buckles: VW Sharan II / SEAT Alhambra
Step-by-step removing and installing front belt buckles for the VW Sharan II / SEAT Alhambra: 4 steps, 2 torque figures.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 40 Nm (30 lb-ft) | Remove bolt (1 |
| 50 Nm (37 lb-ft) | Remove bolt (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove seat .
- Release wiring harness from fastenings in seat frame.
- Remove bolt (1) (40 Nm). — 40 Nm (30 lb-ft)
- Remove belt buckle (2) from seat frame.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Assembly overview - lower part of sump, upper part of sump, oil pump, engine oil cooler
- Allocation of main bearing shells for new crankshaft
- Assembly overview - lower part of intake manifold with fuel rail
- Steering column switch module (SCSM)
- Assembly overview - poly V-belt drive, air conditioner compressor
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.