Removing and installing rear outer seat belt buckles: VW Touareg II
Step-by-step removing and installing rear outer seat belt buckles for the VW Touareg II: 3 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touareg II (7P, 2010–2018)
Don't miss
- After installing the belt buckle, you must always check the spring function. — Push the belt buckle down. The belt buckle must automatically swing upwards again.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 50 Nm (37 lb-ft) | Unscrew bolt (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove bench seats .
- Unscrew bolt (1) (50 Nm) and remove belt buckle (2). — 50 Nm (37 lb-ft)
- ⚠ After installing the belt buckle, you must always check the spring function. — Push the belt buckle down. The belt buckle must automatically swing upwards again.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Transmission mount (EA 827 engine) - replace · 3 torque figures
- Rear window wiper motor V12 - remove and install · 3 torque figures
- Sunroof glass roof (height adjustment) - adjust · 2 torque figures
- Loosening and tightening twelve-point head bolt, with ribbing, securing drive shaft · 3 torque figures
- Loosening and tightening threaded connections of drive shaft · 3 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.