Removing and installing rear belt buckles, Passat CC 2009► and CC 2010► — VW
Removing and installing rear belt buckles, Passat CC 2009► and CC 2010► on VW: 3 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat CC (357, 2008–2012), VW Passat B6 (3C, 2005–2010)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 40 Nm (30 lb-ft) | Remove bolts (1) and (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove bench seat, Passat CC 2009► and CC 2010► .
- Remove bolts (1) and (2) (40 Nm) and remove belt buckles (3) and (4) from body. — 40 Nm (30 lb-ft)
- Install in reverse order of removal.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Reverse gear brake "„B1“" - adjust
- Fuel pump (pre-supply pump)G6 check valve - examine
- Electric motor for the Hydraulic gearbox pump V387 - remove and install
- Gearbox hydraulic pressure pump V387 - remove and install
- Generator (Alternator)C (vehicle with CNXA engine) - remove and install
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.