Removing and installing front backrest, front backrest with Easy Entry — VW

🧭 Before you start

Fits: platform codes 121, BL1

Don't miss

• Bolts are microencapsulated and must be renewed each time they are removed.Prior to installation, clean threaded holes for bolts with, for example, a thread chaser.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove front seat .
2. Remove front seat trims .
3. Unscrew bolts (1) for Easy Entry (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
4. Release Easy Entry (2) from seat backrest frame and remove it.
5. Release and lay to side all wiring harnesses and disconnect all connectors.
6. Unscrew bolts (2) and (4). [Note: Bolts are microencapsulated and must be renewed each time they are removed.Prior to installation, clean threaded holes for bolts with, for example, a thread chaser.]
7. Remove backrest (3) from seat pan (1).
8. Install in reverse order of removal.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Adjusting differential for vehicles with engines up to 103 kW
• Adjusting differential on vehicles with engines of 111 kW and above
• Adapting selector lever position display (automatic gearbox)
• Draining and filling hydraulic fluid
• Removing and installing ancillary bracket, engine codes: BCA, BUD