Removing and installing ESP sensor unit — VW
Removing and installing ESP sensor unit on VW: 8 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)
Don't miss
- Do not use the securing nuts to forcibly position ESP sensor unit G419.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 9 Nm (6.6 lb-ft) | Tighten securing nuts |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- ⚠ Severe shocks (e.g. dropping, impact) may destroy the ESP sensor unit G419. The ESP sensor unit G419 may not then be used any further. — Remove centre console General body repairs, interior68Centre console; Removing and installing centre console.
- Pull connector (1) off ESP sensor unit G419.
- Remove the three securing nuts (arrows).
- Remove ESP sensor unit G419.
- Install in reverse order. [Note: Do not use the securing nuts to forcibly position ESP sensor unit G419.]
- Tighten securing nuts to 9 Nm. — 9 Nm (6.6 lb-ft)
- Code control unit J104 with in ”Guided fault finding”.
- Carry out basic setting of "“brake system”" (electromechanical parking brake).
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Checking valve timing (vehicles up to 11/2008) – VW Touareg I
- Emptying fuel tank with fuel pump in good working order (engine codes BSE, BSF)
- Checking quantity injected, engine code BGU – VW Touran I 1.6
- Removing and installing sump, engine codes AXW, BLX, BLY, BLR
- Removing and installing gaiter with selector lever knob and noise insulation, Passat
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.