Removing and installing engine mounting, Polo: VW (CHZB, CHZC)
Step-by-step removing and installing engine mounting, Polo for the VW (CHZB/CHZC): 14 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6C (2014–2017)
📋 Procedure
- Remove bolts (arrows).
- Lift coolant expansion tank until connector is accessible.
- Disconnect connector (1) for coolant shortage indicator switch F66, and lay coolant expansion tank to one side.
- Brace the engine in its installation position. Supporting engine in installation position
- Unscrew nut (1), and lay earth wire (2) to one side.
- Unscrew bolts (arrows) for gearbox mounting support arm.
- Unscrew bolts (arrows), and remove engine mounting (1).
- Place engine mounting (1) onto longitudinal member.
- First screw in bolts (arrows) as far as stop by hand.
- Tighten bolts Assembly overview - assembly mountings.
- First screw in bolts (arrows) for support arm of engine mounting as far as stop by hand.
- Tighten bolts (arrows)Assembly overview - assembly mountings.
- Fit earth strap (2) to stud, start nut (1), and tighten it. Assembly overview - assembly mountings
- Remove support bracket. Supporting engine in installation position
Other VW procedures
- Cleaning throttle valve moduleGX3 – VW Polo 6C
- Removing and installing camshaft oil seal, exhaust camshaft, pulley end
- Removing and installing radiator blind control motor V544
- Removing and installing engine speed sender G28
- Assembly overview - poly V-belt drive, vehicles with air conditioner compressor
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.