Removing and installing driver seat lumbar support adjustment switch E176 — VW
Removing and installing driver seat lumbar support adjustment switch E176 on VW: 9 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 137
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 0.5 Nm (0.4 lb-ft) | Unscrew bolts (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition.
- Move seat to highest position.
- Remove backrest adjuster wheel
- Remove seat height adjuster handle
- Remove trim on sill side
- Disconnect connector (4).
- Unscrew bolts (2) (0.5 Nm). — 0.5 Nm (0.4 lb-ft)
- Remove driver seat lumbar support adjustment switch E176 or E177(1) from trim (3) as applicable.
- Install in reverse order of removal.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing radiator (Golf, Golf Plus, Scirocco, Eos)
- Removing and installing radiator (Tiguan, Passat) – VW 1.4
- Front-wheel drive - renewing right stub shaft oil seal with gearbox installed
- Removing and installing battery for key with remote control > 06.2009
- Removing and installing charge air cooler (Sharan) – VW 1.4
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.