Removing and installing design trim bearings: VW Phaeton

🧭 Before you start

Fits: VW Phaeton (3D)

📋 Procedure

1. Remove centre design trim control motor V208.
2. Remove right design trim control motor V209.
3. Remove left design trim control motor V207.
4. Release locking lugs (A) of bearings.
5. Using a screwdriver, lever out shaft out of bearing in groove (B).

6. Insert screwdriver in groove (arrow) and lever bearing (1) out of housing (2).
7. Proceed in same manner to remove bearing on opposite side.
8. Lubricate new bearings with grease supplied in repair kit.
9. Press bearing with new plastic washers in direction of (arrow) until it engages.
10. Insert opposite bearing with new plastic washer.
11. Position housing with outer side of bearing e.g. on workbench corner.
12. Drive in bearing by knocking it lightly with rubber hammer until it engages.
13. Carry out a functional check.
14. Lubricate connection between control motor and adjustment shaft.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing fuel pressure regulating valve N276
• Removing and installing clutch pedal with extension spring or with over-centre spring, RHD vehicles
• Removing and installing alternator, vehicles with 1.2 l/81 kW TSI engine
• Installing repair kit for headlight housing
• Removing and installing headlight range control motor V48/V49, halogen headlights H7, version 2