Removing and installing dash panel insert, up to model year 2009 — VW
Removing and installing dash panel insert, up to model year 2009 on VW: 6 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf V / Jetta (1K, 2003–2009); platform code AJ5
Don't miss
- There is no need to remove the steering wheel.
- When pulling out dash panel insert, there is no need to separate the connectors. The connector is permanently fitted in the vehicle and is automatically disconnected when dash panel insert is pulled out.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Tighten bolted connections |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical consumers, and remove ignition key. [Note: There is no need to remove the steering wheel.]
- Pull steering wheel fully out and lock it in lowest position.
- Remove upper part of steering column trim General body repairs, interior68Compartments, covers and trim; Removing and installing steering column trim.
- Remove bolts (arrows). [Note: When pulling out dash panel insert, there is no need to separate the connectors. The connector is permanently fitted in the vehicle and is automatically disconnected when dash panel insert is pulled out.]
- Pull dash panel insert out of dash panel in a straight line towards rear of vehicle.
- Tighten bolted connections to 1.5 Nm. — 1.5 Nm (1.1 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing brake master cylinder, RHD vehicles
- Checking operation and power supply of fuel pump
- Removing and installing control unit and hydraulic unit, LHD vehicles, turbodiesel engine
- Adjusting input gear – VW Passat B5 · 3 torque figures
- Checking exhaust gas recirculation cooler for leaks, Polo
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.