Removing and installing coolant pipe (front left): VW Passat B8 (CKFC, CLHA, CLHB, CLHC, …)

🧭 Before you start

Fits: VW Passat B8 (3G, 2014–)

• Opens: coolant

Don't miss

• Secure all hose connections with hose clips meeting production standard Electronic Parts Catalogue.

🔧 Engine codes this applies to

📋 Procedure

1. Remove engine cover panel .
2. Drain coolant .
3. Remove bolts (1, 3).
4. Release fastener (arrow) and remove cover (2).
5. Free coolant hose (2).

6. Release fastener (arrows) and detach air duct (top section) (1).
7. Remove bolt (arrow) on both sides.
8. Unclip air duct (bottom section) (1) and detach.
9. Lift retaining clip (1) and detach connection for coolant.
10. Remove bolt (2).
11. Release hose clips (arrows) and detach coolant hoses.
12. Detach coolant pipe (front left).
13. Remove air filter housing .
14. Lift retaining clip (1) and detach connection for coolant.
15. Remove bolt (2).
16. Release hose clips (arrows) and detach coolant hoses.
17. Detach coolant pipe (front left). [Note: Secure all hose connections with hose clips meeting production standard Electronic Parts Catalogue.]
18. Replenish coolant .
19. Fit engine cover panel .

Other VW procedures

• Removing and installing radiator blind control motor V544
• Removing and installing injector for reducing agent N474
• Removing and installing auxiliary pump for heating V488, version 2
• Removing and installing fuel pressure regulating valve N276, version 2
• Removing and installing exhaust gas temperature sender 2 G448, vehicles with SCR system
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures