AUDI CRUA — 2L Engine
2L · 150 hp
Engine overview
Vehicles with this engine
Engine codes in the same family
The same code prefix usually means the same block with a different output, fuel or model year. Procedures are often shared — check the code on the engine plate.
Workshop procedures for this engine
Step-by-step procedures from the workshop database, carrying 39 torque figures.
- Removing toothed belt from camshaft · 14 torque figures
- Detaching toothed belt from camshaft · 8 torque figures
- Removing and installing emission control module · 3 torque figures
- Renewing vacuum unit for turbocharger · 3 torque figures
- Removing and installing emission control module · 2 torque figures
- Removing and installing camshaft housing · 3 torque figures
- Removing and installing fuel tank, vehicles with front-wheel drive and multi-link rear suspension
- Removing and installing fuel delivery unit/fuel gauge sender, vehicles with four-wheel drive
- Removing and installing valve stem seals (cylinder head installed) · 1 torque figures
- Removing and installing fuel tank, vehicles with front-wheel drive and torsion beam rear suspension
- Removing and installing turbocharger - engine codes CLHA, CRBC, CRBD, CRKB, CRLB, CUNA, CRLC, DBKA, CXXB, CRUA, DEJA, DEJB
- Removing and installing fuel delivery unit/fuel gauge sender, vehicles with front-wheel drive
- Removing and installing fuel delivery unit/fuel gauge sender - vehicles with four-wheel drive
- Removing and installing coolant pipe (front right)
- Removing and installing fuel tank - vehicles with front-wheel drive and multi-link suspension
- Removing and installing rear coolant pipe
- Assembly overview - cylinder block, gearbox end · 3 torque figures
- Removing and installing valve stem seals (cylinder head removed)
- Emptying fuel tank when less then 3/4 full, vehicles with four-wheel drive
- Removing and installing fuel tank - vehicles with front-wheel drive and torsion beam axle
- Removing and installing lower front coolant pipe
- Checking return flow rate of injectors with engine running
- Removing and installing engine support
- Removing and installing exhaust flap control unit J883 · 2 torque figures
- Removing and installing fuel delivery unit/fuel gauge sender - vehicles with front-wheel drive
Got a CRUA problem? Ask for free.
Describe the symptoms — TorqFix replies with a diagnosis cited from verified workshop data.
Get free diagnosis →Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 2 Oct 2026.