Removing and installing charging socket flap unit: VW Passat B8
Step-by-step removing and installing charging socket flap unit for the VW Passat B8: 16 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B8 (3G, 2014–)
📋 Procedure
- Removing radiator grille
- Separate electrical connector for immediate charge button (6) and actuator (5).
- Unscrew bolts (2).
- Rotate charging socket flap unit (1) approx. 90° and remove from radiator grille inwards.
- Rotate charging socket flap unit (1) and bring into installation position.
- Tighten bolts (2), specified torque
- Removing radiator grille
- Separate electrical connector (5) on actuator.
- Unscrew bolts (4) and remove actuator (3).
- Bring actuator (3) into installation position.
- Tighten bolts (4), specified torque
- Removing radiator grille
- Separate electrical connector for immediate charge button (6).
- Unscrew bolts (8) and remove button (7).
- Bring button (7) into installation position.
- Tighten bolts (8), specified torque
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing starter, 2.0 l TSI engine with 147 kW or 155 KW, dual clutch gearbox DQ250-6F
- Removing and installing starter, vehicle with automatic gearbox AQ450
- Checking the current draw of the fuel pump for delivery G6 (0.5 bar low-pressure fuel system)
- Removing and installing engine mountings, Golf Cabriolet and CC
- Removing and installing water radiator for charge air cooling circuit, Golf Cabriolet, CC and Tiguan
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.