Removing and installing camshaft oil seal for exhaust camshaft, gearbox end, type 2 — VW

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

• Special tools named: T10479/3, T10479/2, T10479/1

Don't miss

• Do not lubricate new seal.

🔧 Engine codes this applies to

📐 6 workshop diagrams for CNLA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove toothed belt pulley for coolant pump .
2. Carefully fit extractor hook T20143/1 between camshaft and seal (1).
3. Lever out seal. [Note: Do not lubricate new seal.]
4. Fit seal (1) over fitting sleeve T10479/3 onto guide sleeve T10479/2.
5. Separate fitting sleeve and guide sleeve.

6. Fit guide sleeve T10479/2 with oil seal (2) centrally to camshaft.
7. Locate guide sleeve on camshaft using bolt (1) for toothed belt pulley for coolant pump.
8. Push seal onto camshaft and unbolt guide sleeve.
9. Draw in seal (2) to stop using thrust piece T10479/1 and bolt (1) for toothed belt pulley for coolant pump.
10. Install toothed belt pulley for coolant pump .

Other VW procedures

• Removing and installing fuel system diagnosis pump
• Removing and installing oil spray jets – VW Jetta VI
• Removing and installing toothed belt pulley for coolant pump, type 1
• Removing and installing secondary air pump motor V101
• Removing and installing high-pressure pipe – VW Touareg II
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures