Removing and installing activated charcoal filter, hatchback — VW

🧭 Before you start

Fits: VW Polo 6C (2014–2017); platform code 614

Don't miss

• Make sure that activated charcoal filter engages properly in bracket.
• Do not interchange fuel lines.
• Ensure that fuel lines are tight.

🔧 Engine codes this applies to

📐 36 workshop diagrams for CHYA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Observe safety precautions .
2. Observe rules for cleanliness .
3. Remove rear right wheel housing liner General body repairs, exterior66Wheel housing liner; Assembly overview - rear wheel housing liner.
4. Release fuel lines (2) and (3) from activated charcoal filter (1), and pull them off in direction of (arrow). Separate plug-in connectors .
5. Unscrew bolt (arrow) from activated charcoal filter (1).

6. Disengage fastener (2) in direction of (arrow A).
7. Pull activated charcoal filter (1) downwards ((arrow B)) out of bracket (3).
8. Install in reverse order. Observe the following:
9. Make sure that activated charcoal filter engages properly in bracket.
10. Do not interchange fuel lines.
11. Ensure that fuel lines are tight.

Other VW procedures

• Supporting engine in installation position, support on camshaft housing
• Removing and installing radiator fan V7
• Draining coolant
• Removing and installing camshaft oil seal, pulley end
• Separating engine and gearbox, vehicles with dual clutch gearbox
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures