Rear seat belts "“with automatic belt retractor”" (Fox) - remove and install — VW

🧭 Before you start

Fits: VW Fox (5Z)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove the C-pillar lining (1).
2. Remove the side lining .
3. Remove the belt's lower fastening point, rear area .
4. Remove the C-pillar lining (1).
5. Remove the rear door sill's trim .

6. Remove the belt's lower fastening point, rear area .
7. Remove securing bolts (3) from upper fastening points (4) and belt retractor (2).
8. Tighten securing bolts (3) to (40 Nm) torque. — 40 Nm (30 lb-ft)
9. Install the belt's lower fastening point, rear area, screwing on the fastening screw with torque of (40 Nm) . — 40 Nm (30 lb-ft)

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking operation and power supply of fuel pump, vehicles without fuel pump control unit J538
• Checking heater output
• Removing and installing front part of operating and display unit · 2 torque figures
• Removing and installing fuel tank - vehicles with semi-independent suspension
• Installing seal for roof side member · 1 torque figures