Lower Poly-V belt protector - remove and install — VW
Lower Poly-V belt protector - remove and install on VW: 6 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 6A1, 6A5
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Fasten the hexagonal nut (3), torque |
| 2 Nm (1.5 lb-ft) | Tighten the screws (2): Torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove the screws (2).
- Loosen the hexagonal nuts (3). The hex nut remains in the front lower underbody lining.
- Remove the front lower underbody lining.
- Place the front lower underbody lining (1) into assembly position.
- Fasten the hexagonal nut (3), torque: 2 Nm. — 2 Nm (1.5 lb-ft)
- Tighten the screws (2): Torque: 2 Nm. — 2 Nm (1.5 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing engine control unit J623, CC from 11.2010
- Checking fuel tank breather, engine codes CDLG, CAVB, CAVC, CAVD, CBZA, CBZB, CTHD, CTKA
- Removing and installing windscreen washer pump
- Removing and installing headlight range control unit – VW
- Removing and installing headlight range control regulator E102
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.