Removing and installing windscreen washer pump — VW

🧭 Before you start

Fits: platform code 138

📋 Procedure

1. Remove front right wheel housing liner General body repairs, exterior66Wheel housing liner; Assembly overview - front wheel housing liner.
2. Place drip tray under washer fluid reservoir.
3. Release retaining clips on washer fluid lines (5) and (6).
4. Pull washer fluid lines (5) and (6) off windscreen and rear window washer pump V59(4).
5. Release and disconnect connector (3).

6. Pull windscreen and rear window washer pump V59(4) upwards out of washer fluid reservoir.
7. If necessary, remove sealing grommet for windscreen and rear window washer pump V59 from washer fluid reservoir.
8. Check sealing grommet for damage.
9. Fit sealing grommet correctly into opening in washer fluid reservoir.
10. Moisten sealing grommet with washer fluid to ease installation of windscreen and rear window washer pump V59. [Note: The connections at the pump and hoses are colour-marked to prevent incorrect connection of the washer fluid lines to the windscreen and rear window washer pump V59. The hose fittings must be connected to the correct colour-coded pump connections during installation.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing gearbox, Passat 2011 ►, CC 2012 ► with 3.6 l - V6 petrol engine, all-wheel drive
• Removing and installing rear axle, e-up!
• Removing and installing front 3-point seat belt, 2-door model · 2 torque figures
• Checking cooling output on vehicles with automatically controlled air conditioning system (with high-voltage system)
• Removing and installing decoupler pulley with freewheel‏ – VW · 2 torque figures