Removing and installing engine control unit J623, CC from 11.2010 — VW

🧭 Before you start

Fits: VW Passat CC (357, 2008–2012)

🔧 Engine codes this applies to

📋 Procedure

1. Switch off ignition.
2. Remove plenum chamber cover General body repairs, exterior50Bulkhead; Removing and installing plenum chamber cover.
3. Remove windscreen wiper arms Electrical system92Windscreen wiper system; Removing and installing windscreen wiper arms.
4. Remove plenum chamber bulkhead General body repairs, exterior50Bulkhead; Assembly overview - bulkhead.
5. Push down retaining frame in direction of (arrow) and remove engine control unit.

6. Push locking devices of connectors in (direction of arrow) and pull off connectors.
7. Fit connectors to engine control unit and slide locking devices to stop in (direction of arrow).
8. Place engine control unit into retaining frame and push retaining frame upwards in direction of (arrow).
9. Install plenum chamber bulkhead General body repairs, exterior50Bulkhead; Assembly overview - bulkhead.
10. Fit windscreen wiper arms Electrical system92Windscreen wiper system; Removing and installing windscreen wiper arms.

Other VW procedures

• Removing and installing radiator cowling with radiator fan · 1 torque figures
• Emptying tank for reducing agent
• Removing and installing vacuum pump – VW Phaeton · 1 torque figures
• Checking return flow rate of injectors at starter speed – VW
• Removing and installing engine bracket, Golf Plus
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures