Installing trim on rear bumper: VW Touran I
Step-by-step installing trim on rear bumper for the VW Touran I: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touran I (1T, 2003–2015)
📋 Procedure
- Drill holes (arrows a) for attaching trim with an 8 mm drill bit.
- Deburr holes.
- Remove adhesive residue from bumper cover using adhesive strip removerVAS 6349 and clean surfaces thoroughly with adhesive removerD 002 000 10.
- Set trim (1) against bumper cover and lay ends of protective backing for double-sided adhesive tape outwards.
- Align trim and pull off protective backing.
- Press trim hard against bumper cover in bonding areas (2), exerting counterforce from inside.
- Secure trim to bumper cover using 3 clips (outer arrows a).
- Press on lock washers (inner arrows a) with a socket.
- Press both locking washers (7) onto pins of reflector (5)
- Drill holes (arrows b) in spoiler for clips (6) with an 8 mm drill bit and secure clips.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Gearbox input speed sensor G182
- Abdominal belt with double latch (Saveiro "“double cab”") - remove and install · 1 torque figures
- Abdominal belt with double fastening (rear seat without longitudinal regulation) - removal and installation · 1 torque figures
- Elastic Poly-V belt (vehicles without air conditioner compressor) - remove and install
- Poly-V belt pulley, with no free spin in the alternator - remove and install · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.